BK Precision 9115 Bedienungsanleitung

Model: 9115 Multi-Range DC Power Supply PROGRAMMING MANUAL

STATus:QUEStionable:CONDition? This command is used to read the value of query condition register. When a bit of QUES condition changes, the bit va

Bit Position 7 6 5 4 3 2 1 0 Bit Name Not used Not used Not used CV CC WTG Not used CAL Bit Weight 16 8 4 1 STATus:OPERation:CONDition? This com

2.3 SYSTEM Subsystem SYSTem:ERRor? This command is used to read the error code and the error information. Command syntax: SYST:ERR? Parame

(5) RST checksum failed (10) RAM selftest failed (40) Flash write failed (41) Flash erase failed (213) RS-232 buffer overrun (216) RS-232 recei

Parameter: None SYSTem:POSetup This command configures the power on state of the instrument. Command syntax: SYSTem:POSetup RST|SAV0 Parameter:

interface. Command syntax: ADDRess <NR1> Parameters: 0-31 2.4 TRIGGER Subsystem TRIGger[:IMMediate] This command is used to create a tri

[SOURce:]FALL[:LEVel] This command is used to set the voltage falling time of the power supply. Command syntax: [SOURce:] FALL [:LEVel] <NRf>

Query syntax: [SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]? Return parameter: <NRf> [SOURce:]VOLTage:PROTection[:LEVel] This command is us

Command syntax: [SOURce:]VOLTage:LIMit[:LEVel] <NRf> Parameter: MIN TO MAX|MIN|MAX|DEF Unit: V| mV| uV Query syntax: [SOURce:]VOLTage:LIMit

Command syntax: FETCh:VOLTage? Return parameter: <NRf> Return parameter unit: V MEASure[:SCALar]:CURRent[:DC]? This command is used to read

2.7 LIST AND SEQUENCE Commands LIST Commands LIST:STATe This command is used to set the state of list mode. Command syntax: LIST:STATe <0|1|O

Query syntax: LIST:LINK:SEQuence? Return parameter: 0~1023 LIST:SEQuence:REPeat <NR1>,<NR1> This command is used to edit the running c

Parameter: Parameter1 represents the number of step to be edited.Parameter2 is the current (MIN~MAX). Query syntax: SEQuence:CURRent? <NR1> R

22820 Savi Ranch Parkway Yorba Linda, CA92887 www.bkprecision.com © 2013 B&K Precision Corp.

Table of Contents 1 Remote Operation ... 4 1.1 Interface Connec

1 Remote Operation 1.1 Interface Connection RS-232 For RS-232 connectivity, refer to the diagram below for pin out information. The RS-232 is la

RS-485 For multi-unit configuration and control, the male DB-9 interface labeled RS-485 in the rear panel is used. The below illustrates the connec

2 Remote Commands 2.1 IEEE488.2 Common Commands Here’s a list and description of all common SCPI commands supported by the instrument. *CLS This

*ESR? This command can read the value of standard event status register. After executing this command, standard event status register is reset. Bit

Query syntax: *STB? Parameter: None Returned parameter: <NR1> *TRG When power supply trigger source is a command from via BUS, this command

1 3 4 OC OP OT Over current Over power Over temperature 0 2 3 4 5 7 OPC QYE DDE EXE CME PON Standard event register Operation completed. Al